Logo

U1191 Engine Trouble Code

Meaning of U1191 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U1191 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U1191 code is occuring now you should check U1191 repair processes.
Now don't ask yourself; What should you do with U1191 code ?
The solution is here :

U1191 Possible Solution:

U1191 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

U1191 Code Meaning :

U 1 1 9 1
OBD-II Diagnostic Network (U) Trouble Code For Engine Fuel And Air Metering Fuel Rail/System Pressure - Too High Crankshaft Position Sensor A Circuit Malfunction Crankshaft Position Sensor A Circuit Low Input

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U1191 OBD-II Diagnostic Network (U) Trouble Code Description

U1191 engine trouble code is about Crankshaft Position Sensor A Circuit Low Input.

Main reason For U1191 Code

The reason of U1191 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

U1191 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.